iRobot Scooba 350 Product Manual - Page 22

 I'm Stuck Light When Scooba is stuck, the robot will tell you the cause of the problem by saying "uh-oh" and a number of beeps. Count the beeps after the "uh-oh" and refer to the table below to determine why Scooba is stuck. Usually, when the I'm Stuck light comes on, you need to re-start Scooba in another location. Warning Light I'm Stuck Light Possible Cause What To Do One of Scooba's Inspect Scooba's wheels. Push each wheel up and wheels is off the floor down, place the robot back on the floor and press Clean. (1 beep) The front wheel is stuck (2 beeps) Ensure that the front wheel can spin freely. Lightly push the wheel up and down. The front wheel can easily be removed, cleaned, and replaced. Bumper problem (3 beeps) Tap the bumper to ensure that it moves in and out. Visually inspect the bumper edges for debris. Scooba's cliff sensors are dirty or malfunctioning (4 beeps) Clean cliff sensors with a cotton swab (see page 6 for sensor location). The cliff sensors are located in the bumper and are accessed by turning Scooba over. Left or right wheel malfunction (5 beeps) Inspect Scooba's drive wheels. Spin the wheels by hand and confirm that they offer some resistance. If it does not, or if it's stuck and you can't dislodge the obstruction, contact iRobot customer care. Service Codes Scooba will tell you something is wrong by turning on the Service light and playing a 4-tone alarm followed by a number of beeps. Refer to the table below to resolve Scooba's problem. If the problem persists, visit www.irobot.com/support. Number of Beeps After Alarm 1 2 3 4 5 Likely Cause Pump malfunction Vacuum malfunction Battery failure Charger has failed Battery is too hot What To Do Contact iRobot customer care. Contact iRobot customer care. Contact iRobot customer care. Contact iRobot customer care. Make sure Scooba was not recently filled with hot water or charged in a hot place. Wait for Scooba and battery to cool down and try again. 22 iRobot Scooba Owner's Manual