2004 Buick Rendezvous Owner's Manual - Page 416

Storing the Flat Tire (Vehicles without the Stowable Seat and without the Rear Convenience Center) 1. Flip up the D-ring located in the rear cargo area. 2. Lay the tire in the rear cargo area of the vehicle with the valve stem up with the center hole of the tire over the D-ring. For vehicles with aluminum wheels, remove the center cap by tapping the back of the cap with the folding wrench. 3. Remove the J-hook and the wing nut from the back of the jack access door. Assemble the wing nut and the J-hook. 4. Install the wing nut and the J-hook to the D-ring through the center hole of the tire. 5. Tighten the wing nut to secure the tire to the floor. Push and pull on the tire to make sure the tire is secure and does not move. 6. Put back all tools as they were stored in the jack storage compartment and put the compartment cover back on. Slip the tabs on the side of the compartment cover into the cover opening. Push the cover in place and push down the tabs on the cover so that it rests in the groove. This secures the cover in place. A. B. C. D. E. D-Ring Wing Nut J-Hook Valve Stem Full-Size Tire 5-94