2009 Buick Enclave Owner's Manual - Page 16

2009 Buick Enclave Manual

Page 16 highlights

1-12 Seats and Restraint System 2. Place the seat on the vehicle floor so that the front seat hooks are on the vehicle bars. 3. Reinstall the bolts, and torque to 55 Y (41 lb ft). Pull up on the seat to make sure it is locked in place. 4. Raise the seatback to its upright position. Push and pull on the seatback to make sure it is locked into place. 5. Push the headrest up into position. Push and pull on the headrest to make sure it is locked into place. 6. Reconnect the center safety belt mini-latch to the mini-buckle. Do not let it twist. 5. Remove the seat by tilting it slightly upward, and then pulling it out of the rear of the vehicle in one motion. 6. Replace the bolts in the floor holes for storage. Safety Belts Safety Belts: They Are for Everyone This section of the manual describes how to use safety belts properly. It also describes some things not to do with safety belts. Installing the Third Row Seats 1. Before installing the seat the seatback must be folded forward. See "Folding the Seatback" earlier in this section. The seats must be placed in the proper locations to attach correctly. The wider seat must be installed on the driver side and the narrower seat on the passenger side. Remove the bolts from the holes in the floor before installing the seats. { CAUTION Do not let anyone ride where a safety belt cannot be worn properly. In a crash, if you or your passenger(s) are not wearing safety belts, the injuries can be much worse. You can hit things inside the vehicle harder or be ejected from the vehicle. You and your passenger(s) can be seriously injured or killed. In the same crash, you might not be, if you are buckled up. Always fasten your safety belt, and check that your passenger(s) are restrained properly too.

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.