2009 Buick Enclave Owner's Manual - Page 79

Features and Controls Press the switch to lower the window. Pull up on the front edge of the switch to raise the window. 2-15 Programming the Power Windows If the battery on the vehicle has been recharged, disconnected, or replaced, windows with the express-up feature need to be reprogrammed for this feature to work. To program the window: 1. Close all doors with the ignition in the ACC/ACCESSORY, ON/RUN position, or when Retained Accessory Power (RAP) is active. See Retained Accessory Power (RAP) on page 2-22. 2. Press and continue to hold the window switch until the window is fully open. 3. Pull up and hold the window switch to close the window. Continue to hold it briefly after the window is fully closed. 4. Repeat for each window that has the express-up feature. Express-Down Windows The express-down feature allows the windows to be lowered without holding the switch. Press the window switch fully and release it to activate the express-down feature. The express mode can be canceled by pressing or pulling the switch. Uplevel shown, base similar The power window controls are located on each of the side doors. The driver door also has switches that control the passenger and rear windows. The power windows work with the ignition in ACC/ACCESSORY, ON/RUN or when Retained Accessory Power (RAP) is active. See Retained Accessory Power (RAP) on page 2-22. Express-Up Window The express-up feature allows the windows to be raised all the way without holding the switch up. Pull the switch up fully and release it to activate the express-up feature. The express-up mode can be canceled by pressing or pulling the switch.