2014 Buick Encore Owner Manual - Page 221

Vehicle Care change in many other ways if the wrong replacement brake parts are installed. There are only two reasons why the fluid level in the reservoir might go down: . 10-19 { Warning If too much brake fluid is added, it can spill on the engine and burn, if the engine is hot enough. You or others could be burned, and the vehicle could be damaged. Add brake fluid only when work is done on the brake hydraulic system. When the brake fluid falls to a low level, the brake warning light comes on. See Brake System Warning Light on page 5-15. What to Add Use only new DOT 4 brake fluid from a sealed container. It is recommended that the brake hydraulic system be flushed and refilled with new DOT 4 fluid at a regular maintenance interval every two years. See Recommended Fluids and Lubricants on page 11-11. Brake Fluid The brake master cylinder reservoir is filled with DOT 4 brake fluid as indicated on the reservoir cap. See Engine Compartment Overview on page 10-6 for the location of the reservoir. The fluid level must be between the MIN and MAX marks. The fluid level goes down because of normal brake lining wear. When new linings are installed, the fluid level goes back up. A fluid leak in the brake hydraulic system can also cause a low fluid level. Have the brake hydraulic system fixed, since a leak means that sooner or later the brakes will not work well. . Do not top off the brake fluid. Adding fluid does not correct a leak. If fluid is added when the linings are worn, there will be too much fluid when new brake linings are installed. Add or remove fluid, as necessary, only when work is done on the brake hydraulic system.