1995 Cadillac Eldorado Owner's Manual - Page 137

3. Decide which one of the three channels want to program. Using you both hands, press the hand-held transmitter button and thedesired button on the HomeLink TM Transmitter. Continue to hold both buttons through Step 4. 4. Hold down both buttons until you see the red light on the HomeLink Transmitter flash rapidly. The rapid flashing, which could take up to 90 seconds, indicates that the HomeLink TM Transmitter has been programmed. Release both buttons once thelight starts to flash rapidly. If you have trouble programming the HomeLink TM Transmitter, make sure that you have followed the directions exactly as described and that the batteries in the hand-held transmitter are not dead. If you still cannot program it, rotate your hand-held transmitter end over end and try again. The HomeLink TM Transmitter may not work with older garage door openers that do meet current Federal Consumer Safety Standards. If not you cannot program the transmitter after repeated attempts, consult your Cadillac dealer orcall 1-800-355-35 15. Be sure to keep your original hand-held transmitter in case you need to erase and reprogram the HomeLink TM transmitter. Note to Canadian Owners: During programming, your hand-heldtransmitter may stop transmitting after one or two seconds. If you are programming from one of these transmitters, the HorneLink TM indicator light may prompt you to re-activate your hand-heldtransmitter with a series of double blinks. After you reactivate your hand-held transmitter, the HolneLink TM light should flash rapidly. If it flashes slowly, continue to periodically rc-activate your hand-held transmitter until the light flashes rapidly. Operating the Transmitter Press the appropriatebutton on the HomcLink TM Universal Transmitter. The red light comes on while the signal is being transmitted. Note that the effective transmission range of the HomeLink" Transmitter may differ from your hand-held transmitter and from one channel to another. Erasing Channels To erase all three programmed channels, hold down the two outside buttons until the red light begins to flash. Individual channels cannot be erased, but can be reprogrammed using t h e procedure for programming the transmitter explained earlier. 2-66