1998 Cadillac DeVille Owner's Manual - Page 131

3. Hold the end the hand-held transmitter against the Note to Canadian Owners:During programming, the of hand-held transmittermay stop transmitting afterone or so front surfaceof the universal transmitter that you two seconds.If you are programming from one these of can still see the amber light. on transmitters, you should press and re-press the button 4. Using both hands, press the hand-held transmitter the hand-held transmitter every two seconds without button and the desired button on the universal ever releasingthe button on the universal transmitter. transmitter. Continueto.press both buttons through Release both buttonswhen the amber light on the Step 5. universal transmitter begins to flash rapidly. 5 . Hold down both buttons until you see the amber light Operating the Transmitter on the universal transmitter flash slowly and then rapidly. The rapid flashing, which could take up to Press and hold appropriate button on the universal the 90 seconds, indicates that universal transmitter the transmitter. The amber light comes on while signal is the has been programmed. Release both buttons once the being transmitted. light starts to flash rapidly. Note that the universal transmitter disabled when the is If you have trouble programming the universal box valet button inside the glove is activated. For more transmitter, make sure that you have followed the in information, see "Valet Lockout Button" earlier directions exactly as described and that the battery in the this section. If hand-held transmitter is not dead.you still cannot program it, rotate the hand-held transmitter end over end Also note that if the hand-held transmitter appears to program the universal transmitter but does not open and try again. The universal transmitter may not work if with older garage door openers that do not meet current your garage door, and the garage door opener was manufactured after 1995, the garage door opener may Federal Consumer Safety Standards. you cannot If A program the transmitter after repeated attempts, consult have a "rolling code" system. rolling code system changes the codeof the garage door opener every time your dealer. you open or close the garage door. in case Be sure to keep the original hand-held transmitter you need to erase and reprogram the universal transmitter. To determine if you havethis system, pressthe button on the universal transmitter that you have programmed 2-60