1998 Cadillac DeVille Owner's Manual - Page 184

SIDE: Press this button to change the of the tape side that is playing. (PLAY shows on the display.) SOURCE: Press this button to select a source. If no REV: Press theleft arrow to rewind the tape rapidly. cassette tape isin the tape player, CASS appears on the The radio will play while the reverses and REV tape display and then the radio station appears briefly. The will appearon the display.You may use your station display then reverts back to showing the time of day. Press in pushbuttons to tune to another radio station while this button again orBAND to switch backto the radio. REV mode. Press theleft arrow again to return to playing speed. A EJECT Press the upward triangle button to remove FF:Press theright arrow to fast forward to another part a tape. The radio will play. Eject may be activated with the radio off. Cassette tapesmay be loaded with the radio of the tape. The radio will play while the tape advances off but they will not start playing until the PWR button is and FF will appearon the display.You may use your off pressed. Press PWR orturn the ignition key to stop station pushbuttons to tune to anotherradio station the cassette tape player. The tape will stay in the player while in W mode. Press the right arrow again to and resume play at the point where it stopped. return to playing speed. SEEK-TUNE: Press the right arrow to seek to the next CLN: If this message appears on the display, the cassette tape player needs be cleaned. It will still play to selection on the tape. Press the left arrow to search for tapes, butyou should clean it as soon as possible to the previous selection on the tape (REP will appear on prevent damage to the tapes and player. "Care of See the display). Your tape must have at least three seconds Your Cassette Tape Player" in the Index. After you clean of silence between each selectionfor SEEK-TUNE to the player, press and hold EJECT five seconds to for work. The sound will mute while seeking. --reset the CLN indicator. radio will display to The SCAN: Press this button. SCAN will appearon the FF show the indicator was reset. display until the next selection found and then SCAN is Dolby Noise Reductionis manufactured under a license PLAY will appear on the display. Use SCANlisten to to from Dolby Laboratories Licensing Corporation. Dolby selections for a few seconds. The tape will to a go of and the double-D symbol are trademarks Dolby selection, stop for a few seconds, thengo on to the next Laboratories Licensing Corporation. stop scanning. selection. Press this button again to The cassette tape is broken. (Check tosee if your tape is broken. Try a new tape.) 3-17