1998 Cadillac DeVille Owner's Manual - Page 193

for three seconds. (The EI"y shown will be the last PTY selected.) Press theRDS SELECT button, followed bythis button again toturn the PTY display off. < PTY > (5) (6): With RDS on, press the RDS SELECT button, followed < or > . The PTY display by RDS SELECT PTY will turn on, if it is not already on. NEWS will appear on display for three seconds. the (The PTY shown will be last PTY selected.) While the this message is displayed, use < and > to move up and a down the PTY list.If you pause on PTY for three T seconds, PRESETP Y NEWS will appear on the display. While this messageis displayed, you can save the PTYin a preset by pressing of the six numbered one pushbuttons until you hear a beep. Allow three seconds for the message to disappear ifyou do not want to save (RDS) the PTY in a preset. See "Radio Data Systems Program Type (PTY) Selections'' the Index. in When the PTY display is on, press SEEK and SCAN to find radio stationsof the PTY you want to listen to. The last PTY selected will be used seek and scan modes. for If a station with selected PTYis not found, NONE the If TA FOUND will appear on the display. both PTY and are on, the radio will search stations with traffic for PTY. announcements and the selected PUSHBUTTONS: The six numbered pushbuttons let you return to your favorite Program Types (PTYs). These buttons have factory PTY presets. "Radio See Data Systems (RDS) Program Type (PTY) Selections'' in the Index. You can setup to 12 PTYs (six F"1 and six FM2). Just: 1. Turn PTY on. 2. Press BAND to select FM1or mM2. 3. Tune an RDS station with the PTY you desire. 4. Press and hold oneof the six numbered buttons for more than two seconds until you hear a beep. Whenever you press that numbered button less for than two seconds, the PTY you set will return. 5. Repeat the steps for each pushbutton. When battery power is removed and later applied, you will not have to reset your RDS presets because the radio remembers them. HR or MN: Press the RDS SELECT button, followed for by one of these buttons to display the time the current station.STATION TIMEIS will be displayed. If a time has not been sent to the radio, NO STATION TIME will be displayed. If you have recently tuned to the station, you may need to wait a minute before the To time is available to the radio. set the clock to the