2000 Cadillac Seville Owner's Manual - Page 101

Setting Cruise Control CAUTION: If you leave your cruise control switch on when you're not using cruise, you might hit a button and go into cruise when you don't want to. You could be startled and even lose control. Keep the cruise control switch off until you want to use cruise control. 1. Press the button at the end of the lever to turn on the system. 2. Accelerate to the speed you want. 3. Move the lever down once to SET/CST. The CRUISE light will come on. 4. Remove your foot from the accelerator pedal. Resuming a Set Speed Setting the cruise control at a desired speed and then applying the brake will end the cruise function. Once you're going about 25 mph (40 km/h) or more, you can move the cruise control lever up to RES/ACC (Resume/Accelerate) briefly to reset. This returns you to your desired preset speed. The CRUISE light will come on. If you hold the lever at RES/ACC, the vehicle will accelerate until you release the lever or apply the brake. So unless you want to go faster, don't hold the lever at RES/ACC. Increasing Speed While Using Cruise Control There are two ways to go to a higher speed: D Use the accelerator pedal to go to a higher speed. Move the cruise lever to SET/CST and then release the lever and the accelerator pedal. You'll now cruise at the higher speed. D Move the lever up to RES/ACC. Hold it there until you reach a desired speed and then release the lever. To increase your speed in very small amounts, move the lever up to RES/ACC one second at a time. Each time you do this, your vehicle will go about 1 mph (1.6 km/h) faster. The accelerate feature will only work after you have set the cruise control speed by moving the cruise lever down to SET/CST. 2-41