2014 Cadillac ATS Owner Manual - Page 165

Lighting . 6-3 The IntelliBeam system can be disabled by the High/Low-Beam Changer or the Flash-to-Pass feature. If this happens, the High/Low-Beam Changer must be activated two times within five seconds to reactivate the IntelliBeam system. The instrument cluster light will come on to indicate the IntelliBeam is reactivated. . Your vehicle's windshield is dirty, cracked, or obstructed by something that blocks the view of the light sensor. Your vehicle's windshield is covered with ice, dirt, haze, or other obstructions. Your vehicle is loaded such that the front end points upward, causing the light sensor to aim high and not detect headlamps and taillamps. You are driving on winding or hilly roads. Exterior Lamps Off Reminder A warning chime will sound if the exterior lamp control is left on in either the headlamp or parking lamp position and the driver door is opened with the ignition off. . . The high beams may not turn off automatically if the system cannot detect other vehicle's lamps because of any of the following: . Headlamp High/ Low-Beam Changer 2 3 (Headlamp High/Low-Beam Changer): Push the turn signal lever away from you and release, to turn the high beams on. To return to low beams, push the lever again or pull it toward you and release. . The other vehicle's lamp(s) are missing, damaged, obstructed from view, or otherwise undetected. The other vehicle's lamp(s) are covered with dirt, snow, and/or road spray. The other vehicle's lamp(s) cannot be detected due to dense exhaust, smoke, fog, snow, road spray, mist, or other airborne obstructions. . You may need to manually disable or cancel the high-beam headlamps by turning the low-beam headlamps on, if any of the above conditions exist. This feature can be turned on or off or the sensitivity can be changed in vehicle personalization. See Vehicle Personalization on page 5-43. . This indicator light turns on in the instrument cluster when the high-beam headlamps are on.