2014 Cadillac ATS Owner Manual - Page 306

10-20 Vehicle Care can feel the upper radiator hose getting hot. Watch out for the engine cooling fan. By this time, the coolant level inside the coolant surge tank top chamber may be lower. If the level is lower, add more of the proper DEX-COOL coolant mixture to the surge tank top chamber until the level reaches the bottom of the fill neck. 5. Replace the surge tank pressure cap tightly and close the surge tank service port cap. If the coolant is not at the proper levels, repeat Steps 1-3 and reinstall the pressure cap and close the service port. If the coolant still is not at the proper levels when the system cools down again, see your dealer. surge tank pressure cap and upper radiator hose, is no longer hot. Turn the pressure cap slowly counterclockwise. If you hear a hiss, wait for that to stop. This will allow any pressure still left to be vented out the discharge hose. 2. Keep turning the pressure cap slowly and remove it. Open the surge tank service port cap to the lower chamber 3. Fill the surge tank top chamber with the proper DEX-COOL coolant mixture to the bottom of the fill neck. The top chamber needs to be completely full. Fill the surge tank bottom chamber through the service port to approximately half. 4. With the coolant surge tank pressure cap off and the surge tank service port cap open, start the engine and let it run until you Engine Overheating The vehicle has an indicator to warn of the engine overheating. If the decision is made not to lift the hood when this warning appears, get service help right away. See Roadside Service on page 13-5. If the decision is made to lift the hood, make sure the vehicle is parked on a level surface. Then check to see if the engine cooling fan is running. If the engine is overheating, the fan should be running. If it is not, do not continue to run the engine. Have the vehicle serviced. { Caution If the pressure cap is not tightly installed, coolant loss and possible engine damage may occur. Be sure the cap is properly and tightly secured. Check the level in the surge tank top and bottom chambers when the cooling system has cooled down.