2015 Cadillac SRX Owner Manual - Page 173

6-2 Lighting Keep this area of the windshield clear of debris to allow for best system performance. The high-beam headlamps remain on, under the automatic control, until one of the following situations occurs: . ; (Parking Lamps): Turns on the parking lamps including all lamps, except the headlamps. 3 (Headlamps): Turns on the headlamps together with the parking lamps and instrument panel lights. A warning chime sounds if the driver door is opened when the ignition switch is off and the headlamps are on. # (Front Fog Lamps, If Equipped): Press to turn the lamps on or off. See Front Fog Lamps on page 6-6. This light comes on in the instrument cluster when the IntelliBeam system is enabled. Turning On and Enabling IntelliBeam To enable the IntelliBeam system, with the turn signal lever in the neutral position, turn the exterior lamp control to AUTO. The blue high-beam on light appears on the instrument cluster when the high beams are on. Driving with IntelliBeam The system only activates the high beams when driving over 40 km/h (25 mph). There is a sensor near the top center of the windshield that automatically controls the system. The system detects an approaching vehicle's headlamps. The system detects a preceding vehicle's taillamps. The outside light is bright enough that high-beam headlamps are not required. The vehicle's speed drops below 20 km/h (12 mph). The IntelliBeam system can be disabled by the High/Low-Beam Changer or the Flash-to-Pass feature. If this happens, the High/Low-Beam Changer must be activated two times within five seconds to reactivate the IntelliBeam system. The instrument cluster light will come . . IntelliBeam® System If equipped, this system turns the vehicle's high-beam headlamps on and off according to surrounding traffic conditions. The system turns the high-beam headlamps on when it is dark enough and there is no other traffic present. . .