2015 Cadillac SRX Owner Manual - Page 228

Driving and Operating could become active when not desired. Keep the cruise control off when cruise is not being used. Select the set speed desired for cruise. This is the vehicle speed when no vehicle is detected in its path slower than the set speed. ACC will not set at a speed less than 25 km/h (16 mph), although it can be resumed when driving at lower speeds. To set ACC: 1. Press 9-37 Increasing Speed While ACC is at a Set Speed If ACC is already activated, do one of the following: . The ACC indicator displays on the instrument cluster. When the ACC is active, the indicator turns green. Be mindful of speed limits, surrounding traffic speeds, and weather conditions when selecting the set speed. Resuming a Set Speed If the ACC is set at a desired speed and then the brakes are applied, the ACC is disengaged without erasing the set speed from memory. To begin using ACC again, press +RES up briefly. The vehicle returns to the previous set speed. Use the accelerator to get to the higher speed. Press SET- down. Release the control and the accelerator pedal. The vehicle will now cruise at the higher speed. When the accelerator pedal is pressed, ACC will not brake because it is overridden. A warning message will appear on the Driver Information Center (DIC). See Cruise Control Messages on page 5-29. J. 2. Get up to the desired speed. 3. Press and release the SET− control. 4. Remove foot from the accelerator. After ACC is set, it may immediately apply the brakes if a vehicle ahead is detected closer than the selected following gap. . Press and hold +RES up until the desired set speed appears on the display, then release it. To increase vehicle speed in small increments, press +RES up briefly. For each press, the vehicle goes to the next 1 km/h (1 mph) faster mark on the speedometer. .