1996 Chevrolet S10 Pickup Owner's Manual - Page 121

Finding a Station TUNE-AM-FM: Turn this knob to tune in radio stations. Press it to switch betweenAM and FM. In addition to the four stations set as above, upto three additional stations may be preset on each band by pressing two adjoining buttons the same time. Just: at SEEK: Press this button to to the next higher station go and stop. 1. Tune in the desired station. 2. Press SET. (SET will appear on the display.) same time, 3. Press two adjoining pushbuttons at the within five seconds. Whenever you press the same two buttons, the station you set will return. for 4. Repeat these steps each pair of buttons. SCAN: Press this button to listen to each station for a the few seconds. The radio will go to next station, stop for SCAN will a few seconds, then go to the next station. appear on the display. Press SCAN again to stop scanning. PUSHBUTTONS: The four numbered pushbuttons let you return to yourfavorite stations. You can set up to 14 stations (seven AM and seven FM). 1. Tune in the desired station. 2. Press SET. (SET will appear on the display.) Setting theTone BASS: Slide this lever up to increase the bass. Adjust the lever until the sound pleasing to yourear. is TREBLE: Slide this lever up to increase the treble. You can reduce noisefor weak or noisy stations by sliding this lever down. Adjusting theSpeakers BAL: This control ring behind the PWR-VOL-PROG-RCL knob adjusts the balance between the left and right speakers. FADE: This control ring behind the"E-AM-EM knob adjusts the balance between the front and rear speakers. 3. Press one of the four pushbuttons, within five seconds, to store the station. Whenever you press that numbered button, the stationyou set will return. 4. Repeat the steps for each pushbutton. 3-8