2000 Chevrolet Monte Carlo Owner's Manual - Page 123

To program a garage door opener with the rolling code feature, do the following: 1. Program your hand-held transmitter to the HomeLinkR Transmitter by following the steps provided under "Programming the Transmitter" earlier in this section. 2. Remove the cover panel from the garage door opener receiver. It is located near the garage door opener motor. 3. Locate the training button on the garage door opener receiver. The exact location and color will vary among brands. 4. Press the training button on the garage door opener receiver for one to two seconds. 5. Within thirty seconds of pressing the training button, return to your vehicle and press the programmed button on the HomeLinkR Transmitter until the indicator light flashes rapidly (about two seconds). You may now use either the HomeLinkR Transmitter or the hand-held transmitter to open your garage door. If you still have difficulty in programming and require assistance, please call 1-800-355-3515. 6. Release the button, then press it again to confirm it was programmed to the garage door opener receiver. Erasing Channels To erase all three programmed channels, hold down the two outside buttons until the indicator light begins to flash. Individual channels cannot be erased, but can be reprogrammed using the procedure for programming the transmitter explained earlier. Accessories Accessories for the HomeLinkR Transmitter are available from the manufacturer of the unit. If you would like additional information, please call 1-800-355-3515. 2-57