2000 Chevrolet Monte Carlo Owner's Manual - Page 301

8. Push the new bulb into the socket. 9. Push the socket back into the assembly. Tighten the socket by turning it clockwise. 10. Reinstall the assembly and the three lower wing nuts. 11. Reinstall the carpeting. 12. Reinstall the upper (convenience net) wing nut and reattach the convenience net, if equipped. Rear Courtesy Lamps 1. Remove the two access covers from the assist handle assembly using a small coin. 2. Remove the old bulb from the small prongs extending from the dome lamp base plate; hook the new bulb onto the prongs. 3. Remove the two screws with an E8 TORXR socket wrench. Back-Up Lamp 1. Open the trunk. The back-up lamp bulbs are in the rear bumper. 2. Remove the two screws. 3. Pull the assembly from the body of the vehicle. 4. To remove a socket, turn the socket counterclockwise and pull it out. 5. Pull the bulb out. Do not twist it. 6. Push the new bulb into the socket. 7. Push the socket back into the assembly. Tighten the socket by turning it clockwise. 8. Reinstall the assembly with the two screws. 4. Pull the assist handle assembly out and remove the old bulb. 5. Reverse Steps 1 through 3 to reassemble. 6-40