2009 Chevrolet Aveo Owner's Manual - Page 230

Then, without shutting off the engine, follow these steps: 1. Locate the automatic transmission dipstick which is located toward the front of the engine compartment, near the power steering fluid reservoir. See Engine Compartment Overview on page 5-14 for more information on location. 2. Pull out the dipstick and wipe it with a clean rag or paper towel. 3. Push the dipstick back in all the way, wait three seconds, and then pull it back out again. How to Add Automatic Transmission Fluid Refer to the Maintenance Schedule to determine what kind of transmission fluid to use. See Recommended Fluids and Lubricants on page 6-13. If the fluid level is low, add only enough of the proper fluid to bring the level into the area between the two dimples in the hot range on the dipstick. 1. Pull out the dipstick. 2. Using a long-neck funnel, add enough fluid at the dipstick hole to bring it to the proper level. It does not take much fluid, generally less than one pint (0.5 L). Do not overfill. Notice: Use of the incorrect automatic transmission fluid may damage the vehicle, and the damages may not be covered by the vehicle's warranty. Always use the automatic transmission fluid listed in Recommended Fluids and Lubricants on page 6-13. 3. After adding fluid, recheck the fluid level as described under "How to Check Automatic Transmission Fluid" earlier in this section. 4. When the correct fluid level is obtained, push the dipstick back in all the way. 4. Check both sides of the dipstick. The fluid should be between MIN (A) and MAX (B) mark of the hot area of the dipstick. 5. If the fluid level is in the acceptable range, push the dipstick back in all the way. 5-22