2005 Dodge Ram 2500 Pickup Owner Manual - Page 140
2005 Dodge Ram 2500 Pickup Manual
Page 140 highlights
140 UNDERSTANDING THE FEATURES OF YOUR VEHICLE NOTE: Some gate operators and garage door openers may require you to replace this Programming Step 3 with procedures noted in the ЉGate Operator/Canadian ProgrammingЉ section. 4. The HomeLink indicator light will flash slowly and then rapidly after HomeLink successfully receives the frequency signal from the hand-held transmitter. Release both buttons after the indicator light changes from the slow to the rapid flash. 5. Press and hold the just trained HomeLink button and observe the indicator light. If the indicator light stays on constantly, programming is complete and your device should activate when the HomeLink button is pressed and released. NOTE: To program the remaining two HomeLink buttons, begin with ЉProgrammingЉ step two. Do not repeat step one. If the indicator light blinks rapidly for two seconds and then turns to a constant light, continue with ؆Programming؆ steps 6-8 to complete the programming of a rolling code equipped device (most commonly a garage door opener). 6. At the garage door opener receiver (motor-head unit) in the garage, locate the ЉlearnЉ or ЉsmartЉ button. This can usually be found where the hanging antenna wire is attached to the motor-head unit. 7. Firmly press and release the ЉlearnЉ or ЉsmartЉ button. (The name and color of the button may vary by manufacturer.) NOTE: There are 30 seconds in which to initiate step eight.