2005 Dodge Stratus Owner Manual Coupe - Page 138

138 INSTRUMENTS AND CONTROLS Operation Press and hold the desired button (A, B or C) on the universal transceiver until the garage door or other device begins to operate. The indicator light (D) shows that the signal is being transmitted. The hand held transmitter (E) may also be used at any time. NOTE: • If you have difficulty in programming, call toll-free for customer assistance at 1-800-355-3515, or the internet at www.homelink.jci.com. • If your hand held transmitter appears to program the universal transceiver, but your garage door or other device does not operate, and your device was manufactured after 1996, your garage door opener or other device may have a "Rolling Code" system. To check if your device is protected by a "Rolling Code" system: • Check the owner's manual for the device for mention of "Rolling Code". • The hand held transmitter appears to program the universal transceiver but the universal transceiver does not activate the garage door. • Press and hold the programmed button on the universal transceiver. If the indicator light (D) flashes rapidly and then stays on after 2 seconds, the device has the "Rolling Code" feature. "Rolling Code" Programming On garage door openers with the "Rolling Code" feature, the transmitter code changes after each use to prevent the copying of your code. Set the universal transceiver by following these steps: NOTE: • The assistance of a second person may make the following programming procedure quicker and easier.