2012 Dodge Grand Caravan Owner Manual - Page 238

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 235 3. Simultaneously press and hold both the Homelink௡ NOTE: You have 30 seconds in which to initiate the next button you want to program and the hand-held transmit- step after the LEARN button has been pressed. ter button. 6. Return to the vehicle and press the programmed 4. Continue to hold both buttons and observe the indi- HomeLink௡ button twice (holding the button for two cator light. The Homelink௡ indicator will flash slowly seconds each time). If the garage door opener/device and then rapidly after Homelink௡ has received the fre- activates, programming is complete. quency signal from the hand-held transmitter. Release NOTE: If the garage door opener/device does not both buttons after the indicator light changes from slow activate, press the button a third time (for two seconds) to to rapid. complete the training. 5. At the garage door opener motor (in the garage), To program the remaining two HomeLink௡ buttons, locate the "LEARN" or "TRAINING" button. This can repeat each step for each remaining button. DO NOT usually be found where the hanging antenna wire is erase the channels. attached to the garage door opener/device motor. Firmly press and release the "LEARN" or "TRAINING" button. Reprogramming A Single HomeLink௡ Button On some garage door openers/devices there may be a To reprogram a channel that has been previously trained, light that blinks when the garage door opener/device is follow these steps: in the LEARN/TRAIN mode. 1. Turn the ignition switch to the ON/RUN position. 3