2012 Dodge Grand Caravan Owner Manual - Page 240

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 237 to pick up the signal during programming. Similar to this Reprogramming A Single HomeLink௡ Button To reprogram a channel that has been previously trained, Canadian law, some U.S. gate operators are designed to time-out in the same manner. follow these steps: It may be helpful to unplug the device during the cycling process to prevent possible overheating of the garage 2. Press and hold the desired HomeLink௡ button until door or gate motor. the indicator light begins to flash after 20 seconds. Do not 1. Turn the ignition switch to the ON/RUN position. release the button. 1. Turn the ignition switch to the ON/RUN position. 3. Without releasing the button proceed with "Program- 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) ming A Non-Rolling Code" Step 2 and follow all remain- away from the HomeLink௡ button you wish to program while keeping the HomeLink௡ indicator light in view. ing steps. 3. Continue to press and hold the HomeLink௡ button, while you press and release ("cycle"), your hand-held transmitter every two seconds until HomeLink௡ has successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when fully Canadian radio frequency laws require transmitter sigtrained. nals to time-out (or quit) after several seconds of transmission - which may not be long enough for HomeLink௡ Canadian/Gate Operator Programming For programming transmitters in Canada/United States that require the transmitter signals to "time-out" after several seconds of transmission. 3