2012 Dodge Grand Caravan Owner Manual - Page 241

238 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 4. Watch for the HomeLink௡ indicator to change flash Reprogramming A Single HomeLink௡ Button rates. When it changes, it is programmed. It may take up To reprogram a channel that has been previously trained, to 30 seconds or longer in rare cases. The garage door follow these steps: may open and close while you are programming. 1. Turn the ignition switch to the ON/RUN position. 5. Press and hold the programmed HomeLink௡ button 2. Press and hold the desired HomeLink௡ button until and observe the indicator light. the indicator light begins to flash after 20 seconds. Do not • If the indicator light stays on constantly, program- release the button. ming is complete and the garage door/device 3. Without releasing the button proceed with should activate when the HomeLink௡ button is "Canadian/Gate Operator Programming" Step 2 and pressed. follow all remaining steps. • To program the two remaining HomeLink௡ buttons, Using HomeLinkா repeat each step for each remaining button. DO To operate, press and release the programmed NOT erase the channels. HomeLink௡ button. Activation will now occur for the If you unplugged the garage door opener/device for programmed device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lightprogramming, plug it back in at this time. ing, etc.,). The hand-held transmitter of the device may also be used at any time.