1997 Ford Aerostar Owner's Manual - Page 274

2. 3. 4. Snap the retaining wire over both sides of the bulb and connect the electrical connector. Position the headlamp on the vehicle and install the four attaching screws. Turn the headlamps on and make sure that they work properly. If the headlamp was correctly aligned before you changed the bulb, you should not need to align it again. Removing the High-Mount Brakelamp Bulb Liftgate models To remove the brakelamp and bulb: 1. 2. 3. 4. Remove the two screws from the surface of the lens. After removing the screws, remove the lamp assembly. Disconnect the high-mount brakelamp wiring connector. Remove the screw retaining the bulb holder assembly, pull the bulb holder assembly away from the lamp, and pull the bulb straight out of the holder. Push bulb(s) into bulb holder assembly. Place bulb holder assembly on lamp and install retaining screw. Tighten screw. Connect the high-mount brakelamp wiring connector. Position the lamp assembly on the vehicle. Install and tighten the two screws. To replace/install the brakelamp: 1. 2. 3. 4. 5. 275