2007 Ford F150 Owner Guide 3rd Printing - Page 118

Driver Controls 4. Press the ODO reset button in the cluster, hold for six seconds and release. You will see that ZONE appears in the instrument cluster display. 5. Press and release the button until the desired zone number appears. Note: The range of zone values are from 01 to 15 and "wraps" back to 01. 6. When you get to the desired ZONE number, hold the button down to "lock in" the new value. The cluster display will return to the "normal" mode when the button has not been pressed for 6 seconds. Compass calibration adjustment Perform this adjustment in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) and make sure all vehicle doors are shut. 1. Start the vehicle. 2. To enter the compass calibration mode, press and hold the button for greater than eight seconds. The display will then show CAL in the display window. 3. Drive the vehicle slowly (less than 3 mph [5 km/h]) in circles until CAL indicator turns off. As many as 5 complete circles may be required. 4. The compass is now calibrated. MESSAGE CENTER (IF EQUIPPED) With the ignition in the ON position, the message center, located on your instrument cluster, displays important vehicle information through a constant monitor of vehicle systems. You may select display features on the message center for a display of status preceded by a brief indicator chime. The system will also notify you of potential vehicle problems with a display of system warnings followed by a long indicator chime. If equipped with an outside temperature display, it will display in the instrument cluster all the time, except when a warning message is present. 118 2007 F-150 (f12) Owners Guide (post-2002-fmt) USA (fus)