2010 Ford F150 Regular Cab Owner Guide 3rd Printing - Page 106

Driver Controls • If the indicator light blinks rapidly for two seconds and then turns to a constant light continue with "Programming" Steps 4 through 6 to complete programming of a rolling code equipped device (most commonly a garage door opener). 4. At the garage door opener receiver (motor-head unit) in the garage, locate the "learn" or "smart" button (usually near where the hanging antenna wire is attached to the unit). 5. Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer.) Note: There are 30 seconds in which to initiate Step 6. 6. Return to the vehicle and firmly press, hold for two seconds and release the programmed HomeLink௡ button. Repeat the press/hold/release sequence again and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming. HomeLink௡ should now activate your rolling code equipped device. To program additional HomeLink௡ buttons begin with Step 1 in this section. For questions or comments, please contact HomeLink௡ at www.homelink.com or 1-800-355-3515. Gate Operator & Canadian Programming During programming, your hand-held transmitter may automatically stop transmitting - not allowing enough time for HomeLink௡ to accept the signal from the hand-held transmitter. After completing Step 1 outlined in the Programming section, replace Step 2 with the following: Note: If programming a garage door opener or gate operator, it is advised to unplug the device during the "cycling" process to prevent overheating. • Continue to press and hold the HomeLink௡ button (note Step 2 in the Programming section) while you press and release - every two seconds ("cycle") your hand-held transmitter until the frequency signal has been accepted by the HomeLink௡. The indicator light will flash slowly and then rapidly after HomeLink௡ accepts the radio frequency signal. • Proceed with Step 3 in the Programming section. 106