2010 Ford F150 Regular Cab Owner Guide 3rd Printing - Page 111

Driver Controls the Erasing the Car2U௡ Home Automation System buttons procedure and then programming all of the devices being used. Fixed code programming Note: Do not program the Car2U௡ system with the vehicle in the garage. Make sure that your key is on and engine off while programming the transmitter. 1. To program units with fixed code DIP switches, you will need the garage door hand-held transmitter, paper and a pen or pencil. 2. Open the battery cover and record the switch settings from left to right for all 8 to 12 switches. Use the figure below: When a switch is in the up, on, or + position, circle "L." When a switch is in the middle, neutral, or 0 position, circle "M." When a switch is in the down, off, or - position, circle "R." Switch position 1 Up, on or + L Middle, neutral or 0 M Down, off or - R L=left; M=middle; R=right 2 3 4 5 6 7 L L L L L L M M M M M M R R R R R R 8 L M R 9 L M R 10 11 12 L L L M M M R R R 3. To input these positions into the Car2U௡ system, simultaneously press all three Car2U௡ system buttons for a few seconds and then release to put the device into programming mode. The indicator lights will blink slowly. Within 2.5 minutes enter your corresponding DIP switch settings from left to right into your Car2U௡ system by pressing and releasing the buttons corresponding to the settings you circled. 111