2010 Ford Flex Owner Guide 2nd Printing - Page 115

Driver Controls the Erasing the Car2U௡ Home Automation System buttons procedure and then programming all of the devices being used. Fixed code programming Note: Do not program the Car2U௡ system with the vehicle in the garage. Make sure that your key is on and engine off while programming the transmitter. 1. To program units with fixed code DIP switches, you will need the garage door hand-held transmitter, paper and a pen or pencil. 2. Open the battery cover and record the switch settings from left to right for all 8 to 12 switches. Use the figure below: When a switch is in the up, on, or + position, circle "L." When a switch is in the middle, neutral, or 0 position, circle "M." When a switch is in the down, off, or - position, circle "R." Switch position 1 2 3 4 Up, on L L L L or + Middle, neutral M M M M or 0 Down, R R R R off or - L=left; M=middle; R=right 5 L M R 6 L M R 7 L M R 8 L M R 9 L M R 10 L M R 11 L M R 12 L M R 115 2010 Flex (471) Owners Guide, 2nd Printing USA (fus)