2010 Ford Flex Owner Guide 2nd Printing - Page 117

Driver Controls To erase programming on the Car2U௡ system (individual buttons cannot be erased), use the following procedure: 1. Firmly press the two outside Car2U௡ system buttons simultaneously for approximately 20 seconds until the indicator lights begin to blink rapidly. The indicator lights are located directly above the buttons. 2. Once the indicator lights begin to blink, release your fingers from the buttons. The codes for all buttons are erased. If you sell your vehicle equipped with the Car2U௡ system, it is recommended that you erase the programming for security reasons. FCC and RSS-210 Industry Canada Compliance The Car2U௡ system complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received including interference that may cause undesired operation. Changes and modifications to the Car2U௡ system transmitter by other than an authorized service facility could void authorization to use the equipment. MANUAL LIFTGATE The liftgate area is only intended for cargo, not passengers. You can open and close the liftgate from outside the vehicle. The liftgate cannot be opened from the cargo area. Note: In the event of a loss of power, the latch can be accessed and released from the inside using the access panel on the liftgate trim. 117 2010 Flex (471) Owners Guide, 2nd Printing USA (fus)