2001 Honda Odyssey Owner's Manual - Page 102
2001 Honda Odyssey Manual
Page 102 highlights
HomeLink Universal Transmitter Canadian Owners: The remote control you are training from may stop transmitting after two seconds. This is not long enough for the HomeLink transmitter to learn the code. Release and press the button on the remote control every two seconds until the transmitter has learned the code. 5. The red light in the transmitter should begin flashing. It will flash slowly at first, then rapidly. 6. When the red light flashes rapidly, release both buttons. The transmitter should have learned the code from the remote control. 7. Plug in the garage door opener motor, then test the transmitter button by pushing it. It should operate the garage door. If the button does not work, repeat this procedure to train it again. If it CONTINUED Instruments and Controls still does not work, you may have a variable or rolling code garage door opener. Test this by pressing and holding the HomeLink transmitter button you just trained. If the red light blinks for two seconds, then stays on, you have a rolling code garage door opener. You may be able to verify this with the manufacturer's documentation. Go to "Training With a Rolling Code System." 8. Repeat these steps to train the other two transmitter buttons to operate any other remotelycontrolled devices around your home (lighting, automatic gate, security system, etc.). Training With a Rolling Code System For security purposes, newer garage door opening systems use a "rolling" or variable code. Information from the remote control and the garage door opener are needed before the HomeLink transmitter can operate the garage door opener. The "Training the Transmitter" procedure trains the HomeLink transmitter to the proper garage door opener code. The following procedure synchronizes the HomeLink transmitter to the garage door opener so they send and receive the correct codes.