2009 Honda Accord Owner's Manual - Page 154

Main Menu Table Of Contents Playing the FM/AM Radio (EX, EX-L and V6 models without navigation system) To Play the Radio The ignition switch must be in the ACCESSORY (I) or ON (II) position. Turn the system on by pushing the power/volume knob or the AM or FM button. Adjust the volume by turning the power/volume knob. The band and frequency that the radio was last tuned to are displayed. To change bands, press the AM or FM button. On the FM band, ST will be displayed if the station is broadcasting in stereo. Stereo reproduction in AM is not available. On the AM band, AM noise reduction turns on automatically. To Select a Station You can use any of five methods to find radio stations on the selected band: tune, skip, scan, the preset buttons, and auto select. On the FM band, you can also use the features provided by the radio data system (RDS). For more information on the RDS, see page 153 . TUNE Use the selector knob to tune the radio to a desired frequency. Turn the knob right to tune to a higher frequency, or left to tune to a lower frequency. SKIP The skip function searches up and down from the current frequency to find a station with a strong signal. To activate it, press and hold the or side of the SKIP bar until you hear a beep, then release it. Each time you press and release either side of the SKIP bar, the radio frequency changes in small increments. SCAN The scan function samples all stations with strong signals on the selected band. To activate it, press the SCAN button, then release it. You will see SCAN in the display. The system will scan for a station with a strong signal. When it finds one, it will stop and play that station for about 10 seconds. If you do nothing, the system will scan for the next strong station and play it for 10 seconds. When it plays a station that you want to listen to, press the SCAN button again. Features CONTINUED 151 2009 Accord Sedan