2008 Jeep Commander Owner Manual - Page 162

162 UNDERSTANDING THE FEATURES OF YOUR VEHICLE This can usually be found where the hanging antenna wire is attached to the garage door opener motor (it is NOT the button normally used to open & close the door). 6. Firmly press and release the "learn" or "training" button. The name and color of the button may vary by manufacturer. NOTE: There are 30 seconds in which to initiate the next step after the "Learn" button has been pressed. 7. Return to the vehicle and press the programmed HomeLink௡ button twice (holding the button for 2 seconds each time). If the device is plugged in and activates, programming is complete. If the device does not activate, press the button a third time (for 2 seconds) to complete the training. If you are have any problems, or require assistance, please call toll-free 1-800-355-3515 or, on the Internet at www.HomeLink.com for information or assistance. To program the remaining two HomeLink௡ buttons, repeat each step for each remaining button. DO NOT erase the channels. 1 - Garage Door Opener 2 - Training Button