2010 Mercury Mariner Owner Guide 1st Printing (Spanish) - Page 487

Locks and Security Note: The MyKey™ can be cleared within the same key cycle that it was created, otherwise a standard key (Administrator key) is required to disable the MyKey™ programming. To clear all MyKeys™ go to step 2 in the Disable MyKey™ section. Programming MyKey™ Optional Settings Turn the ignition on using an Admin key. To program the optional settings, use the message center buttons to do the following: 1. Press SETUP until RESET FOR MYKEY SETUP is displayed. 2. Press and release the RESET button to display MyKey™ setup menus. The first menu shown is: MYKEY MAX MPH OFF 3. If you don't want to change the maximum speed setting, press the SETUP button to display the next menu. The remaining menus appear as follows with the default settings shown: MYKEY MPH TONES 45 55 65 MYKEY VOLUME LIMIT OFF MYKEY ADVTRAC CTRL ON . 4. On any of the menus press RESET to highlight your choice with the . 5. Press SETUP to enter your choice. The next optional setting will be displayed. 6. Repeat steps 4 and 5 until you are done changing the optional settings. Disable MyKey™ To reset all MyKeys™ as Admin keys do the following: 1. Turn the vehicle on using the Admin key. 2. Press SETUP until PRESS RESET TO CLEAR MYKEY is displayed. 3. Press and release the RESET button. HOLD RESET TO CONFIRM CLEAR is displayed. 4. Press and hold the RESET button for two seconds until ALL MYKEYS CLEARED is displayed. Check MyKey™ System Status The vehicle System Check will provide the status of the following MyKey™ parameters: • MYKEY MILES - This odometer only tracks mileage when a MyKey™ is used. If mileage does not accumulate as expected, then the 107 2010 Mariner (mrn) Owners Guide, 1st Printing USA (fus)