1999 Nissan Maxima Owner's Manual - Page 75
1999 Nissan Maxima Manual
Page 75 highlights
¼ replace the hand-held transmitter batteries with new batteries. ¼ position the hand-held transmitter with its battery area facing away from the HomeLink surface. ¼ press and hold both the HomeLink and hand-held transmitter buttons without interruption. ¼ position the hand-held transmitter 2 to 5 inches (50 to 127 mm) away from the HomeLink surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times. If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this Owner's Manual. indicator light begins to flash (approximately 20 seconds). ROLLING CODE PROGRAMMING Rolling code garage door openers (or other rolling code devices) which are "code protected" and manufactured after 1996, may be determined by the following. A. Reference the garage door opener Owner's Manual for verification. B. The hand-held transmitter appears to program the Integrated HomeLink Universal Transceiver but does not activate the garage door. C. Press and hold the trained HomeLink button. If the garage door opener has the rolling code feature, the HomeLink indicator light will flash rapidly, then remains on after 2 seconds. To program the Integrated HomeLink Universal Transceiver to a garage door opener with the rolling code feature, follow these instructions after completing the "Programming HomeLink " (the aid of a second person may make the following procedures quicker and easier). 1. Locate the training button on the garage door opener motor unit. Exact location and color of the button may vary by garage door opener brand. If there is difficulty locating the training button, reference the garage door opener Owner's Manual. 2. Press the training button on the garage door opener motor unit (which may activate a training light). NOTE: Following step 2, there are 30 seconds in which to initiate step 3. 3. Firmly press and release the programmed HomeLink button. Press and release the HomeLink button a second time to complete the training process. (Some garage door openers may require you to do this procedure a third time to complete the training.) The garage door opener should now recognize the Integrated HomeLink Universal Transceiver and activate when the HomeLink button is pressed. The remaining two buttons may now be programmed (if not yet programmed, follow steps 2 through 4 in the "Programming HomeLink " procedures earlier in this section). CLEARING THE PROGRAMMED INFORMATION Individual buttons cannot be cleared, however to clear all programming, press and hold the two outside buttons and release when the REPROGRAMMING A SINGLE HomeLink BUTTON To reprogram an Integrated HomeLink Uni- 2-32 Instruments and controls