2003 Nissan Maxima Owner's Manual - Page 103

During this step, do not turn the ignition to any positions other than ON. 4. Push the SET switch and, within 5 seconds, push the memory switch 1 or 2 fully for at least 1 second. The indicator light for the pushed memory switch will come on and stay on for approximately 5 seconds after pushing the switch. After the indicator light goes off, the selected positions are stored in the selected memory (1 or 2). If memory is stored in the same memory switch, the previous memory will be deleted. two times with the ignition key in the LOCK position. 2. Reset the desired position using the previous procedure. System operation The automatic drive positioner system will not work or will stop operating under the following conditions: ¼ when the vehicle speed is above 4 MPH (7 km/h). ¼ when any two or more of the memory switches are simultaneously pressed while the automatic drive positioner is operating. ¼ when the adjusting switch for the driver's seat is turned on while the automatic drive positioner is operating. ¼ when the cancel switch located on the instrument panel is pushed to cancel. ¼ when the memory switch 1 or 2 is not pushed for at least 1 second. ¼ when the seat has already been moved to the memorized position. ¼ when no seat position is stored in the memory switch. ¼ when the parking brake is not applied. - M/T models ¼ when the vehicle speed is above 4 MPH (7 km/h) while the parking brake is applied. - M/T models To restart the drive positioner system, Selecting the memorized position 1. A/T models: Set the automatic transmission selector lever to the P (Park) position. M/T models: Apply the parking brake securely when the vehicle is stopped. 2. Turn the ignition ON. 3. Push the memory switch 1 or 2 fully for at least 1 second. The driver's seat will move to the memorized position with the indicator light flashing. Then the light will stay on for approximately 5 seconds. When memory switch 1 or 2 is pushed with the driver's door open and then the key inserted into the ignition switch within approximately 1 minute, the driver's seat will move to the memorized position. - A/T models only Confirming memory storage ¼ Turn the ignition ON and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored the position, the indicator light will stay on for approximately 5 seconds. ¼ If the battery cable is disconnected, or if the fuse blows, the memory will be canceled. In such a case, reset the desired positions using the following procedures. 1. Open and close the driver's door more than 3-18 Pre-driving checks and adjustments