2005 Nissan Maxima Owner's Manual - Page 36

CHILD RESTRAINT INSTALLATION ON REAR SEAT CENTER (5-passenger models only) OR OUTBOARD POSITIONS WARNING ● The three-point seat belt in your vehicle is equipped with an automatic locking mode retractor which must be used when installing a child restraint. ● Failure to use the retractor's locking mode will result in the child restraint not being properly secured. The restraint could tip over or otherwise be unsecured and cause injury to the child in a sudden stop or collision. ● The 4-passenger model has seating and seat belts for 4 occupants, 2 in the front seats and 2 in the rear seats. Never use the rear console as a seating position or for a child restraint. LRS0412 1. Position the child restraint on the seat. Always follow the restraint manufacturer's instructions. The back of the child restraint should be secured against the vehicle seat back. If necessary, adjust or remove the head restraint to obtain the correct child restraint fit. See "Head restraint adjustment" earlier in this section. If the head restraint is removed, store it in a secure place. Be sure to install the head restraint when the child restraint is removed. If the seating position does not have an adjustable head restraint and it is interfering with the proper child restraint fit, try another seating position or a different child restraint. Front Facing (outboard) - step 1 Front facing When you install a child restraint in the rear seat, follow these steps: 1-20 Safety-Seats, seat belts and supplemental restraint system