2006 Nissan Murano Owner's Manual - Page 174

REAR VIEW MONITOR (if so equipped) ¼ "Newfoundland" zone After selection, the CLOCK SETTINGS screen will appear. The GPS time (manual time) corresponding to the selected zone will be displayed. "Pacific" zone has been set as the initial (default) setting. Beep setting: When Beep setting is on (indicator light on), a beep will sound if any audio button is pushed. SAA1329 When the selector lever is shifted into the R (Reverse) position, the monitor display shows view to the rear of the vehicle. The system is designed as an aid to the driver in detecting large stationary objects to help avoid damaging the vehicle. The system will not detect small objects below the bumper and may not detect objects close to the bumper or on the ground. WARNING ¼ The rear view camera is a convenience but it is not a substitute for proper backing. Always turn and check that it is safe to do so before backing up. Always back up slowly. ¼ Objects viewed in the rear view monitor differ from actual distance because a wide-angle lens is used. Objects in the rear view monitor will appear visually opposite like ones viewed in the inside and outside mirrors. ¼ Make sure that the lift gate is securely closed when backing up. "DAY/NIGHT" BUTTON To change the display brightness, push the "DAY/NIGHT" button. Pushing the button again will change the display to DAY or NIGHT display. Then, adjust the brightness moving the joystick right or left. If no operation is done within 10 seconds, or if the "BACK" button is pushed, the display will return to the previous display. Selecting the time zone 1. Select the "Select Time Zone" key. The TIME ZONE screen will appear. 2. Select one of the following zones depending on the current location. ¼ "Pacific" zone ¼ "Mountain" zone ¼ "Central" zone ¼ "Eastern" zone ¼ "Atlantic" zone Display screen, heater, air conditioner and audio systems 4-19