2006 Nissan Murano Owner's Manual - Page 223
2006 Nissan Murano Manual
Page 223 highlights
¼ The SET indicator light may blink when the cruise control main switch is turned on while pushing the RESUME/ACCELERATOR, SET/COAST, or CANCEL switch. To properly set the cruise control system, perform the preceding steps in the order indicated. To set cruising speed, accelerate your vehicle to the desired speed, push the SET/COAST switch and release it. (The SET indicator light will come on.) Take your foot off the accelerator pedal. Your vehicle will maintain the set speed. ¼ To pass another vehicle, depress the accelerator pedal. When you release the pedal, the vehicle will return to the previously set speed. ¼ The vehicle may not maintain the set speed on winding or hilly roads. If this happens, drive without the cruise control. SPA2178 1. RESUME/ACCELERATOR switch 2. SET/COAST switch 3. CANCEL switch 4. MAIN (ON/OFF) switch To cancel the preset speed, follow any of these methods: a) Push the CANCEL switch. The SET indicator light will go out. b) Tap the brake pedal. The SET indicator light will go out. c) Turn the main switch off. Both the CRUISE indicator and SET indicator lights will go out. ¼ If you depress the brake pedal while pushing the RESUME/ACCELERATOR set switch and reset at the cruising speed, turn the main switch off once and then turn it on again. ¼ The cruise control will automatically be cancelled if the vehicle slows down below approximately 8 MPH (13 km/h). CRUISE CONTROL OPERATIONS The cruise control allows driving at a speed between 25 to 89 MPH (40 to 144 km/h) without keeping your foot on the accelerator pedal. To turn on the cruise control, push the main switch on. The CRUISE indicator light on the meter panel will come on. 5-22 Starting and driving