2007 Nissan Sentra Owner's Manual - Page 160
2007 Nissan Sentra Manual
Page 160 highlights
mode appears in the display. Press the TUNE button to adjust Bass and Treble to the desired level. You can also use the TUNE button to adjust Fader and Balance modes. Fader adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. To change the Beep to ON or OFF, press the TUNE button up or down. This will enable or disable the beep sound heard during menu selection. Once you have adjusted the sound quality to the desired level, press the AUDIO/CLOCK button repeatedly until the radio or CD display reappears. Otherwise, the radio or CD display will automatically reappear after about 5 seconds. Clock operation Press the AUDIO/CLOCK button to display the clock when the radio is off. Clock set 1. Press and hold the AUDIO/CLOCK button for more than 2 seconds to enter the clock set mode. 2. Press the AUDIO/CLOCK button until the hour flashes in the display screen, then press the TUNE button or to adjust the hour. 3. Press the AUDIO/CLOCK button again until the minutes flash in the display screen, then or to press the TUNE button adjust the minutes. 4. Press the AUDIO/CLOCK button again to exit the clock set mode. To move quickly through the channels, press and or button. hold either the SEEK (tuning) button: or to tune Press the SEEK button from high to low or low to high frequencies and stop at the next broadcasting station. RPT·SCAN (tuning) button: Press the RPT·SCAN button to stop at each broadcasting station for 5 seconds. SCAN will illuminate in the display while scan tuning. Pressing the RPT·SCAN button again during this 5 second period will stop the scan tuning and the radio will remain tuned to that station. If the RPT·SCAN button is not pressed within 5 seconds, scan tuning moves to the next station. Station memory operations: 18 stations can be set for the FM and AM radio to the A, B and C preset button in any combination of AM or FM stations. 1. Press the PRESET A·B·C button to change between storage banks. The radio displays the icon A, B or C to indicate which set of presets are active. FM/AM radio operation FM/AM band select: Pressing the RADIO button will change the band as follows: AM ←→ FM When the RADIO button is pressed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. If a compact disc is playing when the RADIO button is pressed, the compact disc will automatically be turned off and the last radio station played will come on. The FM stereo indicator, ST, illuminates during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. TUNE button: Press the TUNE button manual tuning. or for 4-22 Display screen, heater, air conditioner, audio and phone systems