2013 Nissan Versa Owner's Manual - Page 79

2013 Nissan Versa Manual

Page 79 highlights

status. Then the oil display status switches to odometer and twin trip odometer/trip computer information mode that was displayed before the ignition switch was placed in the ACC, OFF or LOCK position. The oil level display status provides specific information regarding your approximate engine oil level. If the oil level is sufficient, "Oil Good" is displayed for approximately 10 seconds. If the oil level is low, "Oil Lo" blinks for approximately 30 seconds in order to draw your attention to necessary action. Quickly push and release the trip computer A on the instrument panel lochange button ᭺ B during the "Oil cated near the speedometer ᭺ Good" or "Oil Lo" mode to display an approximate oil level indication. In case of low engine oil level, see "Engine oil" in the "Maintenance and do-it-yourself" section for the proper engine oil refilling procedure. start flashing and the display shows the current interval. Push the switch to increase the interval distance. Each step increases the interval distance by 500 miles (1,000 km). The interval distance can be set up to 18,000 miles (30,000 km) after which the display returns to zero. If no further action is made, the display returns to oil display status indication and the new interval is set. If the interval distance is set to 0, the display will skip the distance to oil change information and wrench symbol display mode and will directly display the oil display status ("Oil Good" or "Oil Lo"). In order to return to the distance to oil change information and wrench symbol display A mode, push the trip computer change button ᭺ on the instrument panel located near the speedB for approximately 3 seconds after the ometer ᭺ ignition switch has been turned to the ON position, and adjust the distance to oil change schedule as previously described. See the Warranty Information & Maintenance Booklet for the appropriate interval distance to oil change. CAUTION ● The oil level should be checked regularly. Operating with insufficient amount of oil level can damage the engine and such damage is not covered by the warranty. ● NISSAN recommends checking the oil level every 3,000 miles (5,000 km). Oil change schedule set up It is possible to adjust the interval distance to oil change by pushing the trip computer change A on the instrument panel located near button ᭺ B for 3 seconds while the the speedometer ᭺ wrench symbol and distance to oil change are displayed. The symbol and distance display will 2-10 Instruments and controls

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286
  • 287
  • 288
  • 289
  • 290
  • 291
  • 292
  • 293
  • 294
  • 295
  • 296
  • 297
  • 298
  • 299
  • 300
  • 301
  • 302
  • 303
  • 304
  • 305
  • 306
  • 307
  • 308
  • 309
  • 310
  • 311
  • 312
  • 313
  • 314
  • 315
  • 316
  • 317
  • 318
  • 319
  • 320
  • 321
  • 322
  • 323
  • 324
  • 325
  • 326
  • 327
  • 328
  • 329
  • 330
  • 331

status. Then the oil display status switches to
odometer and twin trip odometer/trip computer
information mode that was displayed before the
ignition switch was placed in the ACC, OFF or
LOCKposition.
The oil level display status provides specific in-
formation regarding your approximate engine oil
level.
Iftheoillevelissufficient,“OilGood”isdisplayed
for approximately 10 seconds. If the oil level is
low,“OilLo”blinksforapproximately30seconds
in order to draw your attention to necessary ac-
tion.
Quickly push and release the trip computer
change button
°
A
on the instrument panel lo-
cated near the speedometer
°
B
during the “Oil
Good” or “Oil Lo” mode to display an approxi-
mateoillevelindication.
Incaseoflowengineoillevel,see“Engineoil”in
the “Maintenance and do-it-yourself”section for
theproperengineoilrefillingprocedure.
Oilchangeschedulesetup
Itispossibletoadjusttheintervaldistancetooil
change by pushing the trip computer change
button
°
A
on the instrument panel located near
the speedometer
°
B
for 3 seconds while the
wrench symbol and distance to oil change are
displayed. The symbol and distance display will
start flashing and the display shows the current
interval. Push the switch to increase the interval
distance. Each step increases the interval dis-
tanceby500miles(1,000km).Theintervaldis-
tancecanbesetupto18,000miles(30,000km)
afterwhichthedisplayreturnstozero.
Ifnofurtheractionismade,thedisplayreturnsto
oildisplaystatusindicationandthenewintervalis
set.
Iftheintervaldistanceissetto0,thedisplaywill
skip the distance to oil change information and
wrench symbol display mode and will directly
display the oil display status (“Oil Good”or “Oil
Lo”). In order to return to the distance to oil
change information and wrench symbol display
mode,pushthetripcomputerchangebutton
°
A
ontheinstrumentpanellocatednearthespeed-
ometer
°
B
forapproximately3secondsafterthe
ignitionswitchhasbeenturnedtotheONposi-
tion,andadjustthedistancetooilchangesched-
uleaspreviouslydescribed.
See the Warranty Information & Maintenance
Bookletfortheappropriateintervaldistancetooil
change.
CAUTION
The oil level should be checked regu-
larly.
Operating
with
insufficient
amountofoillevelcandamagetheen-
gineandsuchdamageisnotcoveredby
thewarranty.
NISSAN recommends checking the oil
levelevery3,000miles(5,000km).
2-10
Instrumentsandcontrols