2013 Nissan Versa Owner's Manual - Page 86
2013 Nissan Versa Manual
Page 86 highlights
Cruise set switch indicator light (if so equipped) The light comes on while the vehicle speed is controlled by the cruise control system. If the light blinks while the engine is running, it may indicate the cruise control system is not functioning properly. Have the system checked by a NISSAN dealer. For front passenger air bag status light operation, see "Front passenger air bag and status light" in the "Safety - Seats, seat belts and supplemental restraint system" section of this manual. light should After a few driving trips, the turn off if no other potential emission control system malfunction exists. If this indicator light comes on steady for 20 seconds and then blinks for 10 seconds when the engine is not running, it indicates that the vehicle is not ready for an emission control system inspection/maintenance test. See "Readiness for inspection/maintenance (I/M) test" in the "Technical and consumer information" section of this manual. Operation The Malfunction Indicator Light will come on in one of two ways: ● Malfunction Indicator Light on steady - An emission control system malfunction has been detected. Check the fuel-filler cap. If the LOOSE FUEL CAP warning message is displayed in the odometer, and the fuel-filler cap is loose or missing, tighten or install the cap and continue to drive the vehicle. light should turn off after a few The light does not turn driving trips. If the off after a few driving trips, have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. High beam indicator light (blue) This blue light comes on when the headlight high beams are on and goes out when the low beams are selected. The high beam indicator light also comes on when the passing signal is activated. Engine start operation indicator (if so equipped) For vehicles equipped with push button ignition this indicator illuminates when the ignition switch is in the LOCK, OFF, ACC or ON position with the shift selector in the P (Park) position. This indicator means that the engine will start by pushing the push-button ignition switch with the brake pedal depressed. Malfunction Indicator Light (MIL) If this indicator light comes on steady or blinks while the engine is running, it may indicate a potential emission control malfunction. may also come on steady if the fuelThe filler cap is loose or missing, or if the vehicle runs out of fuel. Check to make sure the fuel-filler cap is installed and closed tightly, and that the vehicle has at least 3 gallons (11.4 liters) of fuel in the fuel tank. Front passenger air bag status light The front passenger air bag status light ( ) will be lit and the passenger front air bag will be OFF depending on how the front passenger seat is being used. Instruments and controls 2-17