2014 Nissan Pathfinder Owner's Manual - Page 268

The driver's seat and steering wheel will return to the previous position: ● When the driver's door is closed with the ignition switch placed in the LOCK position. ● When the ignition switch is turned from ACC to ON while the shift lever is in the P (Park) position. The entry/exit function can be adjusted or canceled through the Vehicle Settings in the vehicle information display by performing the following: ● Switch the Exit Seat Slide from ON to OFF. ● Switch the Exit Steering UP from ON to OFF. SETTING MEMORY FUNCTION The position of the following settings can be linked to the Intelligent Key and the memorized settings can be available for each Intelligent Key. ● Climate control system ● Navigation system (if so equipped) ● Audio system To use the memory function, set the climate, navigation and audio systems to the driver's preferred settings. Lock the doors with the Intelligent Key. Each Intelligent Key may be set with the driver's individual preferences. When a new Intelligent Key is used, "Connection with the key has been done" will be displayed on the screen and the memorized settings are available. To engage the memorized settings, perform the following: 1. Carry the Intelligent Key that is linked to the memorized settings. 2. Unlock the doors by pushing the driver's door handle request switch or the button on the Intelligent UNLOCK Key. 3. Place the ignition switch in the "ON" position. The settings linked to the Intelligent Key will start. For further instructions on using the Climate control system see "Heater and air conditioner (automatic)" in "Monitor, climate, audio, phone and voice recognition systems". For further instructions on using the Navigation System, see the separate Navigation System Owner's Manual. For further instructions on using the Audio system, see "Audio system" in "Monitor, climate, audio, phone and voice recognition systems". SYSTEM OPERATION The automatic drive positioner system will not work or will stop operating under the following conditions: ● When the vehicle speed is above 4 MPH (7 km/h). ● When any of the memory switches are pushed while the automatic drive positioner is operating. ● When the adjusting switch for the driver's seat and steering column is turned on while the automatic drive positioner is operating. ● When the seat has already been moved to the memorized position. ● When no seat position is stored in the memory switch. Restarting the entry/exit function If the battery cable is disconnected or if the fuse opens, the entry/exit function will be disabled. Drive the vehicle over 25 MPH (40 km/h) to restart the entry/exit function. You can also restart the entry/exit function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than 2 times with the ignition switch in the LOCK position. The entry/exit function should now work properly. 3-38 Pre-driving checks and adjustments