1997 Oldsmobile Cutlass Supreme Owner's Manual - Page 131
1997 Oldsmobile Cutlass Supreme Manual
Page 131 highlights
RCL: Press this button briefly to recall the station being played or to display the clock. To change whatis normally shown on the display (station or time), press the RCL button until you see the display you want, then hold the RCL button until the display flashes.If you press the button whenthe ignition is off, the clock will show for a few seconds. Finding a Station AM-FM: Press this button to switch between AM, FM1 and FM2. The display shows your selection. PUSHBUTTONS: The five numbered pushbuttons let you return to your favorite stations. You can set up to 15 stations (fiveAM, five FM1 and five FM2). Just: 1. Turn the radio on. 2. Press AM-FM to select the band. 3. Tune in the desired station. 4. Press TONE to select the equalization that best suits the typeof station selected. 5. Press and hold oneof the five numbered buttons. The sound will mute. When it returns, release the TUNE: Press this knoblightly so it extends. Turnit to button. Whenever you press that numbered button, choose radio stations. Push the knob backinto its stored the station you set will return and the tone that you position when you're not using it. selected will also be automatically selected for SEEK: Press the up or down arrow to go to the next that button. higher or lower station and stay there. The sound will 6. Repeat the steps for each pushbutton. mute while seeking. SCAN: Press this button and release it to listen to stations-fora few seconds. The radio will go to a station, stop for a few seconds, then go on to the next station. Press the button again to stop scanning. The sound will mute while scanning, and SCAN will appear on the display. If you press SCAN for more than two seconds, the radio will change to P SCAN mode. P SCAN will appear on the display. P SCAN: Press SCANfor more than two seconds, and P SCAN will appear on the display. The radio will go to the first preset station stored on your pushbuttons, stop for a few seconds, then go on tothe next preset station. Press SCAN again to stop scanning. 3-10