2006 Pontiac G6 Owner's Manual - Page 87

If you enter the vehicle after a remote start, and the engine is still running, insert the key into the ignition switch and turn to ON to drive the vehicle. 4. To manually shut off a remote start, do any of the following. The parking lamps will turn off to indicate the engine is off. The remote vehicle start feature will not operate if any of the follow occur: • The remote start system is disabled through the DIC. • Aim the remote keyless entry transmitter at the vehicle and press and release the remote start button. • Turn on the hazard warning flashers. • Turn the ignition switch ON and then OFF. Your vehicle's engine can be started two times, per ignition cycle, using the transmitter's remote start feature. If only one remote start procedure has been done, since last driving the vehicle, or resetting the remote start system, the engine may be started again remotely by following the remote start procedure a second time. If the remote start procedure is used again before the first 10 minute time frame has ended, 10 minutes will be added to the remaining time. The added 10 minutes are considered a second remote start. The vehicle's key is in the ignition. The vehicle's hood is open. The hazard warning flashers are on. The check engine light is on. See Malfunction Indicator Lamp on page 3-40. • The engine coolant temperature is too high. • The oil pressure is low. • Two remote vehicle starts have already been provided for that ignition cycle. Vehicles that have the remote vehicle start feature are shipped from the factory with the remote start system enabled. The system may be enabled or disabled through the DIC. See "REMOTE START" under DIC Vehicle Personalization on page 3-52 for additional information. 2-9