1998 Subaru Legacy Owner's Manual - Page 174

imum and right side minimum, BAL. 0 for neutral, BAL. R9 for left side minimum and right side maximum). Choose desired setting by turning the volume control knob. The control function returns to volume control mode after about 5 seconds. J FM/AM selection button (FM AM) Push the FM/AM selection button when the radio is on to select FM1, FM2 or AM reception. Each time this button is pressed, the band will change in the following order: FM1 FM2 AM The display indicates which is currently selected. J Stereo indicator The stereo indicator "ST" will come on when an FM stereo broadcast is received. J Manual tuning (TUNE) Press the "TUNE" button marked "Y" to increase the tuning frequency and press the "TUNE" button marked "B" to decrease it. Each time the button is pressed, the frequency changes 10 KHz in the AM waveband and 0.2 MHz in the FM waveband. Constant pressure on the button causes a continuous change in the frequency. J Automatic tuning (SCAN) Press the "SCAN" button to change the radio to the SCAN mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for five seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned from the low end to the high end. Press the "SCAN" button again to cancel the SCAN mode and to stop on any displayed frequency. 5-22