1998 Subaru Legacy Owner's Manual - Page 185

Audio Each time the button is pressed, the frequency changes 10 KHz in the AM waveband and 0.2 MHz in the FM waveband. Constant pressure on the button causes a continuous change in the frequency. B Manual tuning for weather band When weather band mode is selected, press the tuning button marked "Y" to change the WB channel up and press the tuning button marked "B" to change the WB channel down. Each time the button is pressed, the WB channel changes next channel. Constant pressure on the button causes a continuous change in the frequency. J Automatic tuning (SCAN) Press the "SCAN" button to change the radio to the SCAN mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for five seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned from the low end to the high end. Press the "SCAN" button again to cancel the SCAN mode and to stop on any displayed frequency. J Selecting preset stations Presetting a station with a preset button allows you to select that station in a single operation. Up to six AM, FM1, FM2 and WB stations each may be preset. J How to preset stations 1. Press the AM/FM selection button to select either AM, FM1 or FM2 reception. OR Press the "WB" button to select the weather band. 2. Press the "SCAN" button or tune the radio manually until the desired station frequency is displayed. 3. Press one of the preset buttons for at least 1.5 seconds to store the frequency. The frequency of the station will flash once on the display at this time. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory. - CONTINUED - 5-33