2008 Subaru Legacy Owner's Manual - Page 202

Audio 5-11 NOTE While you are holding down either side of the TUNE/TRACK button, the tuning frequency will not stop changing even if the frequency of a receivable station is reached. ! Stereo indicator The stereo indicator "ST" will come on when an FM stereo broadcast is received. ! Seek tuning (SEEK) ! Scan tuning (SCAN) to low frequencies). Automatic tuning may not function properly if the station reception is weakened by distance from the station or proximity to tall buildings and hills. & Station preset ! How to preset stations 1. Press the "FM AM" button to select FM1, FM2 or AM reception. 2. Press the " " or " " side of the button or tune the radio manually until the desired station frequency is displayed. 3. Press one of the preset buttons for more than 1.5 seconds to store the frequency. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory. If you press the " " or " " side of the SEEK/SCAN button briefly, the radio will automatically search for a receivable station and stop at the first one it finds. This function may not be available, however, when radio signals are weak. In such a situation, perform manual tuning to select the desired station. If you press the " " or " " side of the SEEK/SCAN button for 0.5 second or longer, the radio will switch to scan mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for 5 seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned. Press the " " or " " side of the button again to cancel the scan mode and to stop on any displayed frequency. If you hold down the " " side of the button, the radio will scan up the frequency band (from low frequencies to high frequencies). If you hold down the " " side of the button, the radio will scan down the frequency band (from high frequencies NOTE . If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all stations stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset buttons. . If a cell phone is placed near the radio, it may cause the radio to emit noise when it receives calls. This noise - CONTINUED -