2008 Subaru Legacy Owner's Manual - Page 99
2008 Subaru Legacy Manual
Page 99 highlights
2-10 Keys and doors pressed. These lights stay illuminated for approximately 30 seconds if any of the doors or the rear gate (Station wagon) is not opened. If the " " button is pressed before 30 seconds have elapsed, these lights will go out. To activate this function, set the following interior light switches to the indicated positions: Map light: OFF position Dome light: Middle position Cargo area light: DOOR position A SUBARU dealer can change the illumination period setting of the interior lights in accordance with your preference. Contact the nearest SUBARU dealer for details. three times, the system may not respond to the signals from the remote transmitter. & Sounding a panic alarm & Vehicle finder function Use this function to find your vehicle parked among many vehicles in a large parking lot. Provided you are within 30 feet (10 meters) of the vehicle, pressing the " " button three times in a 5-second period will cause your vehicle's horn to sound once and its turn signal lights to flash three times. To activate the alarm, press the "PANIC" button once. The horn will sound and the turn signal lights will flash. To deactivate the panic alarm, press any button on the remote transmitter. Unless a button on the remote transmitter is pressed, the alarm will be deactivated after approximately 30 seconds. give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off. Do the following to deactivate the audible signal. You can also use the same steps to restore the function. 1. Sit in the driver's seat and shut all doors and the rear gate. 2. Hold down the UNLOCK side of the power door locking switch. 3. While holding down the "UNLOCK" side of the power door locking switch, pull the key out and re-insert it into the ignition switch at least 6 times within 10 seconds after Step 2. 4. Open and close the driver's door once within 10 seconds after Step 3. 5. The turn signal lights flash 3 times to indicate completion of the setting. You may have the above settings done by your SUBARU dealer. & Replacing the battery CAUTION . Do not let dust, oil or water get on or in the transmitter when replacing the battery. . Be careful not to damage the printed circuit board in the trans- NOTE If the interval between presses is too short when you press the " " button & Selecting audible signal operation Using an electronic chirp, the system will