3Com 2848 SFP User Guide - Page 56
L'Information De Sécurité Importante, Power Cord Set
UPC - 662705502243
View all 3Com 2848 SFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
56 APPENDIX C: SAFETY INFORMATION Power Cord Set This must be approved for the country where it will be used. U.S.A. and ■ The cord set must be UL-approved and CSA Canada certified. ■ The minimum specifications for the flexible cord are: No. 18 AWG Type SV or SJ 3-conductor ■ The cord set must have a rated current capacity of at least 10 A. ■ The attachment plug must be an earth-grounding type with a NEMA 5-15P (15 A, 125 V) or NEMA 6-15P (15 A, 250 V) configuration. Denmark ■ The supply plug must comply with Section 107-2-D1, Standard DK2-1a or DK2-5a. Switzer- ■ The supply plug must comply with SEV/ASE land 1011. UK ■ The supply plug must comply with BS1363 (3-pin 13-amp) and be fitted with a 5 A fuse which complies with BS1362. ■ The mains cord must be or marked and be of type HO3VVF3GO.75 (minimum). Europe ■ The supply plug must comply with CEE7/7 ("SCHUKO") ■ The mains cord must be or marked and be of type HO3VVF3GO.75 (minimum). WARNING: Fiber optic ports - optical safety CLASS I LASER DEVICE Never look at the transmit laser while it is powered on. Never look directly at the fiber ports and fiber cable ends when they are powered on. WARNING: Use of controls or adjustments of performance or procedures other than those specified herein may result in hazardous laser emissions. L'Information De Sécurité Importante Veuillez lire à fond l'information de la sécurité suivante avant d'installer le Baseline Switch 2848-SFP Plus. AVERTISSEMENT: L'installation et la dépose de ce groupe doivent être confiés à un personnel qualifié. ■ Si vous entassez l'unité Switch avec les unités SuperStack 3 Hub, l'unité Baseline Switch 2816S doit être installée en dessous des unités Hub plus étroites. ■ Ne branchez pas votre appareil sur une prise secteur (alimentation électrique) lorsqu'il n'y a pas de connexion de mise à la terre (mise à la masse). ■ Vous devez raccorder ce groupe à une sortie mise à la terre (mise à la masse) afin de respecter les normes internationales de sécurité. ■ Le coupleur d'appareil (le connecteur du groupe et non pas la prise murale) doit respecter une