3Com 3CRWE20096A User Guide - Page 17

Restoring an Access Point to Factory Defaults 17 4 Follow the instructions to download the files into a directory on your computer. Installing an Upgrade 1 In the Wireless Network Tree, select the access point to be upgraded and click Configure. 2 Under Tools, click Upgrade System. 3 Select the item to upgrade: To upgrade the Web server file system, click the Configuration System Firmware radio button. To upgrade firmware, click the Access Point Firmware radio button. 4 Click Browse, select the upgrade file that you downloaded earlier, and click OK. If you choose the wrong file, click Clear Entry. The selected file is cleared and you can browse again for a different file. 5 Click Upgrade. The upgrade file is copied from your computer to the access point and the access point restarts using the new upgrade. Restoring an Access Point to Factory Defaults You can restore access point settings to the defaults that were set at the factory by inserting a pointed object (such as the point of a straightened paper clip) into the reset hole on the front near the RJ-45 connector and holding for five seconds. Interoperating with Third-Party Equipment Because 3Com 11 Mbps Wireless LAN equipment complies with IEEE 802.11b standards, it can interoperate with third-party equipment that also complies with the standards. However, some third party equipment may not support 3Com enhanced performance features. You may need to turn off the Network Traffic Accelerator and set the Data Preamble to long to support this equipment on the network.